Advantage of Fin Tube Heat Exchanger

Use of a fin tube exchanger works especially well for an air heat exchanger. A finned tube adds a lot of heat transfer surface area for the fluid outside the tube, which is usually air or some other gas for a fin tube exchanger.


For a liquid-liquid heat exchanger, the use of a finned tube isn't normally needed, because the heat transfer coefficient for both sides of the heat transfer surface is relatively high. For an air heat exchanger, however, where one of the fluids is air or some other gas, the air side heat transfer coefficient will be much lower, so additional heat transfer surface area, as in a fin tube exchanger is very helpful. The overall flow pattern for a finned tube exchanger is often crossflow, but it can also be counterflow or parallel flow.

Finned Tube Heat Exchangers

General Configuration of a Fin Tube Exchanger

A finned tube heat exchanger will typically have tubes with fins attached to the outside of them. There will usually be a liquid flowing through the inside of the tubes and air or some other gas flowing outside of the tubes, where the additional heat transfer surface area due to the finned tube, increases the heat transfer rate. For a crossflow fin tube exchanger, the fins will typically be radial fins either circular or square, as shown in the pictures in this section.

Most finned tube heat exchangers are crossflow, using finned tubes somewhat like the upper pictures. For a counterflow or parallel flow fin tube exchanger, the fins should be longitudinal instead of radial, as shown in the lower diagram at the left. Finned tubes may be used as internal tubes in an enclosed heat exchanger, but in many cases with an air heat exchanger, the air flows through an open heat exchanger as shown in the next section, where some typical applications of finned tube heat exchangers are shown and discussed.

SS316L Seamless Tube and Aluminum Fin Composited Finned Tube

Examples of Fin Tube Heat Exchangers

Finned tube heat exchangers are used in a variety of household applications and as industrial heat exchangers. An air heat exchanger like the evaporator coil for an air conditioning unit is typically a fin tube heat exchanger. Another common fin tube air heat exchanger is the car radiator. The purpose of the car radiator is to cool the hot water in the tubes with the air passing through in crossflow. The air conditioner evaporator coil has the purpose of cooling the air passing through it.

A fin tube heat exchanger can be used as an industrial heat exchanger also. An application that has seen widespread expansion recently is 'dry cooling' for steam power plants. This consists of using an air cooled condenser instead of a water cooled condenser. Interest in dry cooling for steam power plants has increased because of concern about the amount of water use and thermal effects on water bodies from the traditional cooling systems, 'once through cooling' and 'closed system - cooling tower cooling.

English Inglés SpanishEspañol

Contac Us

Sunny Steel Blog


Our team are highly trained and experienced in servicing and producing all types of steel supplies. Whether you've got a large construction project, or need parts for industrial machinery, our team of steel fabrication consultants will ensure that your project is provided with the parts you need, when you need them.

Link exchange

Copyright © 2011 Sunny Steel Enterprise Ltd.  All Rights Reserved ICP No.:08010763