Galvanized steel hardness
Home > About Us> Tech & Service

Hot dip galvanized steel pipe

Hot Dip Galvanized Steel Pipe

Galvanized steel hardness

Galvanized Steel are those steel that has been covered with a layer of zinc metal.

Galvanized steel in terms of hardness test is a Brinell hardness, Rockwell hardness, Vickers hardness, Shore hardness, micro-hardness and high-temperature hardness, etc.,

which can be divided into a variety, most of the manufacturers or using a Buchner,Rockwell, Vickers hardness of these three methods.

Brinell hardness measurement principle is the test force F (N) with a certain size, the diameter D (mm) of hardened steel balls or carbide ball pressed into the surface of the metal under test, to maintain a predetermined time after the drop test force, the the indentation average diameter d (mm) measured with a reading microscope, and then the equation Brinell hardness HB value, or the value d from the prepared Brinell hardness table to detect HB Brinell hardness measurement method is suitable for cast iron, non-alloy, annealing and quenching and tempering steel, the determination should not be too hard, too small, too thin and the surface does not allow the larger indentation specimen or workpiece.

Rockwell hardness test when the sample is too small or Brinell hardness (HB) is greater than 450, to switch to a Rockwell hardness measurement. The test method is an apex angle of 120 degrees with a diamond cone or the diameter 1.59mm/3.18mm the ball, pressed into the surface of the material under a certain load, the hardness of the material by the indentation depth obtained.

The Vickers hardness means a standard of the hardness of the material. Vickers hardness there is a small negative Vickers hardness test load 1.961 <49.03N, it applies to a thinner workpiece, the tool surface or coating hardness measurement; micro-Vickers hardness test load <1.961N applicable to the metal foil, , of the ultra-thin surface layer hardness measurement.

Hot dip galvanizing
Galvanized pipe process characteristics
Delivery information:
  • Material: SPHC,SPHD,SPHE,Q195-Q235,SAE1006
  • Size: OD (6-610 mm) x WT (1-50mm)
  • GTC (galvanized threaded and coupling) steel pipe: DN15-DN200 (NB1/2"-NB8")
  • GPE (galvanized plain end) steel pipe: DN15-DN200
  • Grooved steel pipe: DN15-DN200 (NB1/2"-NB8")
  • Section type: round, square, rectangular, oval and other special section type.



English Inglés SpanishEspañol
Tech & service
Sunny Steel Blog
Recommended products
Pipe fittings
Pipe fittings are used to connect pipes.
Welded steel pipes Weld steel pipes
We produce an extensive selection of weld steel pipe
Welded steel pipes Anti corrosion pipe
Anti-corrosio pipe is processed through the preservation
Ceramic-Lined Pipes
from a single spool piece to complete piping systems.
Pipe flanges
Pipe flange are a method of connecting pipes, valves.
Pipe Fitting Accessories
We are passionate in Stub Ends, Bolt Sets, Fasteners


About Sunny Steel

Our team are highly trained and experienced in servicing and producing all types of steel supplies. Whether you've got a large construction project, or need parts for industrial machinery, our team of steel fabrication consultants will ensure that your project is provided with the parts you need, when you need them.

Link exchange